Bookmark This Site Silver Bullet Enterprises Cordless DC Colloidal Silver Generator Instructions

Silver Bullet Enterprises

Producers of Safe, Simple and Economical

Colloidal Silver Generators

and related Products... 

3620 W. 10th St. #180 

Greeley, Colorado 80634

Phone: 720-544-7023         e-mail: sales@silverbulletenterprises.com

CORDLESS DC Colloidal Silver Generator  INSTRUCTIONS

Part I: THE  WIRELESS COLLOIDAL SILVER GENERATOR

Simple Instructions for Making Your Own Colloidal Silver, Using Your CORDLESS Home Colloidal Silver Generator…

Note: It is vital that you read these instructions carefully before attempting to make your first batch of colloidal silver!

Your Home Colloidal Silver Generator Kit contains the following:

Note: To make a high-quality colloidal silver supplement uncontaminated with other chemicals, you MUST use distilled water, available at most large grocery stores for about $1.00 a gallon or less. Keep your distilled water at room temperature. Do not refrigerate.

Step 1.) Fill the 2-oz. dropper bottle up to the bottom of the neck with distilled water.

Step 2.) Crush about 1 teaspoon of sea salt and add it to the water in your 2-oz. dropper bottle. Close the lid and shake well to make sure the sea salt is dissolved in the water. This is your saline solution.

Step 3.) Fill a 16-oz. glass tumbler with distilled water. (A large drinking glass will do – do not use a metal container, as metal will short-circuit the silver-making process.)

Step 4.) Use the dropper from your dropper bottle to add four drops of saline solution into the water in your 16-oz. glass tumbler. (If you are using a smaller glass tumbler, simply add one drop of saline solution for each 4 oz. of water in your tumbler.) THE GLASS MUST BE DEEP ENOUGH FOR THE RODS TO HANG ABOVE THE BOTTOM OF THE GLASS.

Step 5.) Insert the flattened ends of your two-.9999 fine, 14 ga., pure silver rods into the tip jacks on the bottom of your generator. You may want to roll them between a book and the top of a table to make sure they are straight before inserting them into their holders.

Step 6.) Pick up the generator with the two silver rods in place, turn it so the silver rods point downward, and set the generator on top of the glass of water, with the two silver rods extending into the water to within 1 inch or so of the generator box.. The light should begin to emit a dim glow.

Step 7.) The he process has begun.. IMPORTANT: Be sure you do NOT let the silver rods touch each other while they are in the water. If you do, the colloidal silver-making process will stop. Crossed rods also put the maximum drain on your batteries, so be sure to keep them separate. The silver rods should always be at least one or more inches apart while dangled in the water. Do not be concerned if the bulb on your generator box only glows dimly, or even not at all during the process. If you watch carefully, you will observe tiny bubbles of hydrogen begin to rise from one silver rod, while an ultra-fine silver mist begins to come off of the other silver rod. That fine silver mist is the result of millions of microscopic silver ions being driven into the water by the electrical charge from the generator. When using a 16-oz. glass tumbler with properly conductive water at room temperature, each minute of activation should produce a silver colloid of approximately 1 part per million (ppm). Ten to twelve minutes of activation should produce a high-quality working solution of about 10 to 12 ppm. Fifteen minutes of activation should produce a high-quality 15 ppm solution.

Step 8.) Once the generator has run for 10 to 15 minutes (see Step 7 for details on running time), simply lift the generator from the top of the glass which removes the silver rods from the water.. The process will stop immediately. Remove your silver rods from the generator and dry them with a paper towel. Usually, one of your silver rods will have a dark oxide film on it after the process is over. Be sure to use the small scouring pad provided to clean and polish the darkened rods.

Step 9.) Use the plastic spoon to briefly stir your colloidal silver solution, evenly distributing the light silver mist throughout the water. (Do not use a metal spoon for this. Metal is conductive, and will neutralize the electrical charge held by the silver ions in the solution you have just made. This will cause the silver ions to fall out of solution, and will vastly decrease the potency of your colloidal silver.)

Step 10.) When you have finished making your first batch of colloidal silver, add 10 drops of it to the saline solution in your 2-oz. dropper bottle. This will stop fungus growth in your saline solution, and will allow you to store it safely for future use in making more colloidal silver.

Additional Important Tips:

Tip #1: Keep Your Colloidal Silver Out of Bright Light or Direct Sunlight: Colloidal silver is extremely light sensitive. Your homemade colloidal silver should be stored in a darkly tinted glass bottle and kept at room temperature in a dark area such as a cupboard. (Tinted glass bottles ranging from 8 to 32 oz. can be ordered inexpensively through almost any good health food store. If you cannot find a darkly tinted glass bottle, simply tape a piece of brown paper bag around the glass bottle you are storing your silver in. Tinted glass prune juice bottles from your local grocery store work well also, as do tinted beer or wine bottles with a cork stopper.)

Tip #2: Never store colloidal silver in a metal container. The metal will neutralize the electrical charge held by the silver ions, and ruin the potency of your colloidal silver.

Tip #3: Do not use plastic bottles to store your colloidal silver. Most modern plastics are mixed with metals for stability and tend to magnetize very easily which will cause your ionic silver particles to stick to the sides of the plastic container and lose potency.

Tip #4: Do not refrigerate. As the colloid solution becomes colder, the movement of the electrified silver ion particles will slow down and fall out of solution, severely diminishing the potency. Always shake the bottle before using your stored colloidal silver to be sure the silver colloid is evenly distributed.

Tip #5: Do not store near speaker cabinets, television, radio or other strong magnetic fields. Magnetic fields will affect the electrical charge on your silver ions, and diminish potency.

Tip #6: Where to get Sea Salt. Should you need to purchase more sea salt, you can find it at most health food stores for under $2 per pound. Be sure to use pure sea salt with nothing added (no additives) and nothing removed. A product called "Celtic Sea Salt" is often suggested. Another good product often recommended is De Souza’s Solar Sea Salt. (De Souza’s can be reached at 1-800-373-5171. You can purchase solar sea salt from them inexpensively, over the telephone.)

Tip #7: Where to get additional .9999 pure silver rods: You can purchase additional strands of 14 gauge ultra-pure .9999 fine silver rod direct from the distribution company at the address below. The price is $18 for each 12 inch strand of silver rod. For a limited time only, you can purchase silver rod in bulk at a significant discount: five feet of .9999 pure silver rod for only $79(that’s only $15.80 per foot), or ten feet of .9999 pure silver rod for only $139 (that’s only $13.90 per foot)! Order online using your Visa , Mastercard, and American Express or Just send your check or money order to:

Silver Bullet Enterprises

Producers of Safe, Simple and Economical Colloidal Silver

Generators and related Products...

3620 W. 10TH STREET, #180

GREELEY, COLORADO 80634

720-544-7023

WE  ACCEPT MONEY ORDERS,  PERSONAL CHECKS,

VISA , MASTERCARD, AMERICAN EXPRESS, or PayPal

USP II GENERATOR (our most versatile)   USP Generator    Silver &Other Products     Conventional Generators 

Order Form       Literature    Merchandise Disclaimer    Home    Laser Pointer     Links Page

Nebulizer        12vdc to 100vac adapter